USE & OPERATION (CONTINUED)
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
•
The appliance is supplied with a Carbon Dust Filter and Honeycomb Cooling Media.
•
The Carbon Dust Filter and Honeycomb Cooling Media are located inside the Rear Grill. See
Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.
•
Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank
and refill with fresh water, especially if the tank has not been cleaned in a long time.
•
The cleaning frequency for the Honeycomb media depends on local air and water conditions. In areas
where the mineral content of water is high, mineral deposits may build up on the Honeycomb
Cooling Media and restrict air flow. Draining the water tank and refilling with fresh water at least
once a week will help reduce mineral deposits. If mineral deposits remain on the Honeycomb
Cooling Media, the media should be removed and washed under fresh water. The media should
be cleaned every two months or sooner, depending on your needs.
•
For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool
function 15 minutes before turning the unit off.
Removing the Carbon Dust Filter/ Honeycomb Cooling Media:
1.
Carefully push down and pull out the rear grill
from the cooler.
2.
Pull out the Carbon Dust Filter and clean with
water as needed.
3.
Remove all the screws from the Rear Frame and
carefully pull it off the air cooler.
4.
To release the Honeycomb Media, remove the
screws securing the Honeycomb on the Rear
Frame and slide the Honeycomb out of the
frame.
5.
Replace or clean media with water and a damp
cloth as needed.
WARNING:
DO NOT operate the Air Cooler when the Rear Grill
or Rear Frame is removed from the Air Cooler, or
if there is a loose-fitting Rear Grill or Rear Frame.
Doing so can cause serious injury or dangerous
electrical shock.
Figure 1:
Honeycomb
Cooling Media
*Applicable for models with Carbon Dust Filter only.
EN
8
Rear Frame
Rear Grill
Screws
Carbon Dust
Filter