Vetus BOWPRO CANVXCJP Manuel D'installation page 13

4.7 Configuration thrust direction
In the order indicated, perform the operations below:
Switch off the control interface, see 4.4, and wait 5 seconds before
starting the configuration procedure below.
1
10 seconds
1. Put the control interface in configuration mode.
• Press and hold the 'ON/OFF' button for 10 seconds.
2
2 x
didahdi ( . − . )
3
3. Configure thrust direction bow thruster
• Move the joystick to the top left corner
and back. If you hear the signal dah (-),
the thrust direction has reversed, or
• If you do not hear a signal move the joy-
stick to the top right corner. You will hear
the signal dah (-). The thrust direction is
reversed.
• Confirm the setting, go to step 5.
Installation manual BOWPRO control interface CANVXCJP
dididididididid ( . . . . . . )
6 seconds
For the first 6 seconds, the buzzer continuously gives a signal dididid-
ididi..... (. . . . . . ), keep pressing the 'ON/OFF' button. After 10 seconds,
the buzzer gives the signal dididididah ( . . . . - ). Release the button.
2. Press the 'ON/OFF' button twice. You will hear the signal, di-dah-di ( . - . ).
Now the control interface is in configuration mode.
If a different combination of audible signals sounds, first restore the factory settings
(see 4.6) and start checking the thrust direction again (see 4.8).
4
4. Configure thrust direction stern thrus-
ter
• Move the joystick to the bottom left cor-
ner and back. If you hear the signal dah (-)
the thrust direction is reversed, or
• If you do not hear a signal move the joy-
stick to the bottom right corner. You will
hear the signal dah (-). The thrust direc-
tion is reversed.
• Confirm the setting, go to step 5.
OR
dididididah ( . . . . − )
Con guration mode
4 seconds
n
ote
5
5. Press the 'ON/OFF' button once to con-
firm the setting.
ENGLISH
1 x
13
021004.11