Wall-Mounting The Speakers - Yamaha NS-PA41 Mode D'emploi

Wall-mounting the speakers

You can mount the speakers on the wall as follows.
1
Install screws (commercially available) into a
solid wall or wall support as shown in the
illustration. Use 3.5 to 4 mm (1/8") diameter
self-tapping screws.
2
Hang each speaker by its keyhole slots onto
the protruding screws.
Note
Make sure the shaft of the screw is seated in the
narrow part of the keyhole slot. Otherwise, the speaker
may fall.
Wall/wall
support
6 mm
(1/4")
Minimum
20 mm (3/4")
150 mm
(5-7/8")
Warning
• Do not mount the speakers on thin plywood or on
a wall with a soft surface material. Otherwise, the
screws may pull out of the surface and the
speakers may fall, possibly damaging the
speakers or causing personal injury.
• Do not affix the speakers to a wall using nails,
adhesives, or unstable hardware. Long-term use
and vibration may cause the speakers to fall.
• To avoid accidents resulting from tripping over
loose speaker cables, affix the cables to the wall.
• Mount the speakers in a wall location that will be
unlikely to result in injury to an individual's
head.
• If you are not sure of a safe way to install these
speakers, consult a professional installer or a
building contractor.
NS-B40
0.59 kg
(1.30 lbs.)
NS-C40
0.73 kg
(1.61 lbs.)
Installing the speakers
4
En