Publicité
Les langues disponibles
Les langues disponibles
DC Inverter U-match Series Duct Type Unit
The power source capacity must be the sum of the air conditioner current and the current of
① .
other electrical appliances. When the current contracted capacity is insufficient, change the
contracted capacity.
When the voltage is low and the air conditioner is difficult to start, contact the power company
② .
to raise the voltage.
4.7.2 Electrical Wiring
(1). For solid core wiring (Fig.39)
1). Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation about 25
mm (15/16") .
2). Using a screwdriver, remove the terminal screw(s) on the terminal board.
3). Using pliers, bend the solid wire to form a loop suitable for the terminal screw.
4). Shape the loop wire properly, place it on the terminal board and tighten securely with the
terminal screw using a screwdriver.
(2). For strand wiring (Fig.39)
1). Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation about 10
mm (3/8") .
2). Using a screwdriver, remove the terminal screw (s) on the terminal board.
3). Using a round terminal fastener or pliers, securely clamp a round terminal to each stripped
wire end.
4). Position the round terminal wire, and replace and tighten the terminal screw with a
screwdriver.(Fig.40)
CAUTION !
Fig.39
Fig.40
23
Fig.41
Publicité
