Publicité
Les langues disponibles
Les langues disponibles
DC Inverter U-match Series Duct Type Unit
over it the insulation can be directly attached to the drain hose.
(12). Considerations for the unit with the condensate pump:
1). For the unit with the condensate pump, only one drain port at the side close to the electric
box is prepared and only through it the drain hose can be connected.
2). See table 3 for the size of the drain port of the unit with the condensate pump, which is
different from that of the unit without the condensate pump.
3). For the unit with the condensate pump, two drain ports at the bottom are defaulted to be
factory plugged with drain caps. After the installation of the drain hose, these two drain
ports also need to be insulated properly with the same way aforementioned.
4). The drain hose for the unit with the condensate pump should be arranged as shown in the
figure below.
a. The vertical height of the drain hose should be 75mm or less so that it is unnecessary for
the drain port to withstand additional force.
b. When multiple drain hoses are used, their installation should be performed as shown in the
figure below.
Fig.30
Fig.31
Fig.32
19
Publicité
