Publicité
Les langues disponibles
Les langues disponibles
CUTTING OPERATION
METAL BLADE USAGE
Always cut by guiding the head from your right to left.
A metal blade cut best up to the point 1/3 from the edge. Use that area for cutting shrubs, tough and thick weeds. For
cutting young grass, you can use up to 2/3from the tip of blade.
IMPORTANT
Operating at low speed makes it easier for grass,weeds,or twigs to become caught up in the blades, and also it makes the
shaft and clutch wear down more quickly.
WARNING
·For safety reasons,do not use metalreinforced line.
·Do not cool the blade with water in case of using grinder.It may cause cracks on blade.
8.MAINTENANCE
AFTER 25 HOURS OF USE
AIR CLEANER
Check and clean the filter element in warm, soapy water as required. Dry completely before
installing. If the element is broken or installing. If the element is broken or shrunk, replace with
a new one.
Important
A clogged air filter may increase fuel consumption while cutting down the engine power
And operate the brush cutter without the air filter of with a deformed filter element will quickly
ruin the engine.
FUEL FILTER
Take the filter out of the fueling port using a small wire hook.Disconnect the filter assembly
from the fuel pipe and unhook the retainer to disassemble it.Clean the components with
gasoline
77
Publicité
