Qlima P7 Serie Manuel D'utilisation page 75

man_P7-PH7-EU (2023) R8.indd 75 man_P7-PH7-EU (2023) R8.indd 75
CONTINUOUS DRAINGE
- When you plan to leave this unit unused for a long time, please remove
the rubber blockage from the drainage hole at the bottom of unit, and
connect a drain hose to the lower fixing clip. All the water in the water
tank will drain outside.
- If water pump is damaged, continuous drainage can be used, and under this
condition, the water pump is not activated. The unit can also work well.
If water pump is damaged, intermittent drainage can also be used. Under
this condition, when the water full indicator lamp lights up, please connect
a drain hose to the lower fixing clip, then all the water in the water tank will
drain outside. The unit can also work well.
WIFI FUNCTION
1. Long press the SPEED button for 5s, enter the WIFI factory set up mode;
2. When the WIFI indicator flashing quickly, the unit is at the WIFI EZ mode if flashing
slowly, the unit is at the WIFI AP mode;
3. For Wi-Fi and Bluetooth combo devices, turn on Bluetooth and location and allow
the app to access your location (for Android only). The Bluetooth permission
is required too. Wi-Fi and Bluetooth combo devices can be automatically
discovered. Or choose "Portable Air Conditioner( BLE+ Wi–Fi)" in the
application.Then tap on "Wi–Fi Mode" on the top right and selet "Bluetooth";
4. You can realize all the air conditioner functions by the mobile phone APP with the
WIFI connected.
G
MAINTENANCE
G
WARNING!
Switch off the unit and remove the electrical plug from the mains
before cleaning the appliance or filter, or before replacing the filters.
Clean the housing with a soft, damp cloth. Never use aggressive chemicals,
petrol, detergents or other cleansing solutions. For maintenance of the filters,
refer to Chapter D "Air Filter". Do not wash the unit directly. If the conditioner is
damaged, please contact the dealer or repair shop.
G
NOTE!
Never use the air conditioner without screenfilter.
H
STORAGE
Empty the internal water container (refer to Chapter F)
Clean and replace the filter (see also chapter D).
Put the unit in air circulation mode for 2 hours to ensure that the inside
becomes completely dry.
Protect the unit against dust and store it in a dry place.
4
75
20/12/23 17:03 20/12/23 17:03