Qlima P7 Serie Manuel D'utilisation page 72

4
72
man_P7-PH7-EU (2023) R8.indd 72 man_P7-PH7-EU (2023) R8.indd 72
Window Slider Kit Installation
The installation manner of window slider kit is mostly in "horizontal" and
"vertical". As shown Fig.4 and Fig.4a, check the min. and max. size of the window
before the installation.
1. Install the window kit on the window (Fig.4, Fig.4a);
2. Adjust the length of the window slider kit according to the window width or
height, and fix it with the dowel;
3. Insert the Window Connector hose to the hole of the Window Kit
requirements.
Drain pipe installation
A) In dehumidification mode, connect the drainpipe to the upper drainage outlet
on the rear side of the fuselage to drain water out of the machine.
B)The inner water tray inside the air-conditioner has one water level safety
switches, it controls water level. When water level reaches an anticipated height,
the water full indicator lamp lights up.
At this time, the drain pipe is connected to the lowest drainage outlet on the back
of the fuselage, so that the water is discharged from the machine.
A
Upper
drainage
outlet
1. Before using
Notice:
- Operation temperature range:
Maximum cooling Minimum cooling
DB/WB(°C) 35/24 18/12
Maximum heating Minimum heating
DB/WB(°C) 27/--- 7/---
Check up whether the exhaust hose has been mounted properly.
Cautions for cooling and dehumidifying operations:
- When using functions on cooling and dehumidifying, keep an interval of at least
3 minutes between each ON/OFF.
- Power supply meets the requirements.
- The socket is for AC use.
- Do not share one socket with other appliances.
- Power supply is AC220--240V 50Hz
B
Lowest
drainage
outlet
20/12/23 17:03 20/12/23 17:03