Publicité
Les langues disponibles
Les langues disponibles
d
Interlock buttons
h
Lower hinge bracket
ON THE CABINET :
1
Reinstall the door.
• The door is now ready to remount on the
opposite side of the dryer.
• While supporting the door, install the two
small hinge screws removed from the
hinge. Test the swing of the door to make
sure the hinges and latch are properly
aligned and that the door opens, closes and
latches properly in both directions.
• If the door doesn't operate smoothly,
remove the door and then the door cover to
check that the lock rods and interlock
buttons are properly mounted and aligned.
• The interlock buttons should be oriented
correctly and operating smoothly. The
interlock rods should be in the proper
position and should not overlap at the
contact point. (See steps 12-14.)
• If the door is damaged, or if the door does
notwork after reassembly, contact the call
centerat 1-800-243-0000.
e
Lower hinge filler
i
Top lock rod holder
f
Side lock rod
j
Lower hinge assembly
Installing the Vent Kit
WARNING
• Use long-sleeved gloves and safety glasses.
• Use a heavy metal vent.
• Do not use plastic or thin foil ducts.
• Clean old ducts before installing the appliance.
The appliance is configured to vent to the rear. It
can also vent to the bottom or side.
NOTE
• An adapter kit, part number 383EEL9001B, may
be purchased from your LG retailer. This kit
contains duct components necessary to change
the appliance vent location.
• Right-side venting is not available on gas
models.
Side Venting
1
Remove the rear exhaust duct retaining screw
a
and pull out the exhaust duct
b
2
Press the tabs on the knockout
carefully remove the knockout for the desired
vent opening. (Right-side venting is not
available on gas models.) Press the adapter
INSTALLATION
19
g
Upper hinge assembly
k
Upper hinge filler
b
.
a
c
and
Publicité
