Sony Glasstron PLM-S700E Mode D'emploi page 29

Using the Glasstron
You need to set a password the first time you use the Glasstron or after you reset the Glasstron.
Set the password following the procedure in "Setting the password" (pages 27 and 28).
Before you start...
Be sure to follow the procedures in "Connecting the Glasstron" (pages 14 to 19) and "Wearing
the Glasstron" (page 20).
1
Turn on the Glasstron using the POWER switch, then press PUSH
DISPLAY jog dial.
Change the display language before
pressing the jog dial, if necessary.
If you have set the Glasstron to operate without a password, go to step 3.
2
Turn the PUSH DISPLAY jog dial to enter the first number of your
password, then press the jog dial. Enter the second and third
numbers in the same way.
If you enter a wrong password, the
message shown on the right appears.
Enter the correct password.
If you have entered a wrong password
more than five times, after about ten
seconds, the Glasstron turns off
automatically.
POWER / POWER SAVING
ON / OFF
PUSH DISPLAY
Screen
DISPLAY LANGUAGE
ENGLISH
FRANÇAIS
DEUTSCH
ITALIANO
NEDERLANDS
ESPAÑOL
SEL EXEC
ENTER THE THIRD NUMBER
OF YOUR PASSWORD.
123
SEL EXEC
Entered password
INCORRECT PASSWORD.
ENTER THE FIRST NUMBER
AGAIN.
1
SEL EXEC
INCORRECT PASSWORD.
SEE THE USER'S MANUAL.
continued
29
-GB