Zanussi ZBA 6190 Mode D'emploi page 49

Fix cover (Hc) on guide (Ha) until it clips into place
Ha
Hc
PR33
Open the appliance door and the furniture door at
8mm
90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure. .
Ha
Hb
PR167
Remove the brackets and mark a distance of 8 mm
8mm
from the outer edge of the door where the nail must
be fitted (K).
K
Ha
Place the small square on the guide again and fix it
with the screws supplied.
Should the lining up of the furniture door be
necessary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
Hb
PR168
Fix cover (Hd) on guide (Hb) until it clips into place.
Hb
Hd
PR167/1
49