Electrolux EQT6540BOG Notice D'utilisation page 50

50 www.electrolux.com
An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
There is no signal when
you touch the panel sen-
sor fields.
comes on
comes on
and number come on. There is an error in the
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the Customer Care Department.
Give the data from the rating plate, three-
digit-letter code for the glass ceramic (it is
in the corner of the cooking surface) and
an error message that comes on.
8. INSTALLATION
WARNING!
Refer to "Safety information"
chapter.
Problem Possible cause
There is water or fat
stains on the control pan-
el.
You put something on
one or more sensor fields.
You put something on the
sensor field .
The roasting zone is not
hot because it operated
only for a short time.
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
appliance.
If you operated the appliance incorrectly,
the servicing by a customer service tech-
nician or dealer will not be free of charge,
even during the warranty period. The in-
structions about the customer service and
conditions of guarantee are in the guaran-
tee booklet.
Before the installation of the appliance, re-
cord the information below from the rating
Remedy
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the roasting zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
Activate the signals (refer
to "OffSound Control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Disconnect the fuse from
the electrical system of
the house in order to dis-
connect the appliance
from the electrical supply
for some time. Connect it
again. If comes on
again, speak to the serv-
ice centre.
Before the installation