BH FITNESS G6495FB Instructions De Montage Et Utilisation page 17

Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
Fig.B
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor, as shown in Fig.1.
The assistance of a second person
is recommended for the assembly
stage.
Make sure that all of the pieces are
present: (1) Monitor;
structure; (11) Strut (left); (11-1) Strut
(right); (106) Lower strut cover (Left);
(107) Lower strut cover (right); (1-1)
Handlebar with handgrip; (8) Handrail
left; (8-1) Handrail
Handlebar Cover; (4) Handrail cover
left; (4-1) Handrail cover right; (6) back
cover for the monitor; (139) Bottle.
Fig.2 Screws and fasteners
(120) Allen screw M-8x15 (10); (42)
Allen screw M-5x10 (4); (2) Allen
screw M8x60 (4); (39) Self tapping
screw 5x25 (2); (112) Self tapping
screw 4x12 (2); (40) Screw M-5x15
(4); (135) Nut M-6 (4); (136) Flat
Washer M-6; (119) 6mm Allen key;
(118) 5mm Allen key; (140) Bottle of
lubricant; (37) Safety key; (86) Mains
cable; (122) Combination spanner;
(17) Screws M-4x8 (4).
Follow these step-by-step assembly
instructions.
At least two people are needed for
these steps.
When fitting the side struts, one
person should hold the strut while the
other one tightens the screws (120).
This will avoid any possible accidents.
1. FITTING THE SIDE STRUTS.-
First, take the right-hand strut (11-1),
Fig.3. Insert the tip of the control cable
through hole (M) tying it to the guide
cable inserted in the strut Fig.3, pull
the tip (O) out through the top of the
strut, as shown in Fig.3, then insert
the side strut into the bottom right-
hand support on the structure in the
direction of the arrow and use screws
(120) to secure it. Fit the control cable
cap (N) into hole (M) on the side strut.
(56) Main
Now take the left-hand side strut (11),
Fig.3.
Insert the strut into the bottom left-
hand support on the structure in the
direction of the arrow and secure it
right; (1-2)
using screws (120).
2. FITTING THE HANDRAILS.-
Take the right handrail (8-1) and insert
the tip of the terminal, marked red, in
through the handlebar (1-1), insert the
handrail onto the handlebar tube (1-1)
in the direction of the arrow, as shown
in Fig.4. Make sure that the holes on
the handrail are lined up correctly.
Take the left handrail (8) and insert
the handrail onto the handlebar tube
(1-1) in the direction of the arrow, as
shown in Fig.4. Make sure that the
holes on the handrail are lined up
correctly.
Next, take the cable for the right
handlerail (P), Fig.4 and insert it
through hole (R) at the bottom of the
handlebar (1-1) and pull it out through
the central hole on the handlebar
Fig.5.
17