Installation; Parent Unit; Baby Unit; Placement - Alecto DBX-20 Mode D'emploi

7.

INSTALLATION

Parent Unit:

Slide down the battery cover located at the back of the parent unit
and place the supplied rechargeable battery pack into the battery
compartment. The connector plug only fits one way into the com-
Bm1120 Bm11
partment. Be sure not to force it.
Connect one of the included power adaptors with the
DC5V connection located on the left side of the parent
unit and place the adapter into a 230V electrical power
outlet. The adapter will now provide power to the parent unit while also
simultaneously charging the battery pack.
The battery pack will need to be charged for at least 24
hours before using the monitor.
The parent unit comes with a belt clip. With this belt clip you can
carry and use the baby unit hands free.

Baby Unit:

Connect one of the included power adaptors with the DC5V
connection into the right side of the baby unit and place the adapter into
the 230V electrical power outlet. The baby unit is now ready for use.
The baby unit does NOT have a battery operating function.

Placement:

Place the baby unit in the nursery room approximately 2 meters away from the
baby.
MAKE SURE THAT THE BABY CANNOT TOUCH THE ADAPTER CORD. ALSO
MAKE SURE THE BABY UNIT CANNOT FALL INTO THE CRIB.
Do not place the baby unit or the parent unit in direct sunlight or in a
damp place. The baby monitor is not waterproof. Too much moisture may
cause damage to the electronics.
8.

HOW TO USE

Switch on: (parent unit + baby unit)

Hold down the
seconds until the power light comes
on (baby unit) or the display lights up
(parent unit).
Press the
to turn the unit off.
Bm1120 Bm11
C
Bm1120
button for about 3
button again for 3 seconds
C
Bm1120 Bm11
-28-
Bm1120 Bm11
Power-
light
display
Button
GB
C