Philips Ultinon H1-LED Mode D'emploi page 21

Section
①
Do not touch!
Please check car installation manual and
②
follow instructions for lamp replacement
③
Low beam / high beam
④
O
⑤
Distance D
Typical application: wide D (keep
⑥
center ring)
⑦
Special case: narrow D (remove center ring)
⑧
Go to Option A / B / C / D
⑨
Pin
⑩
Reference gap
⑪
Final position
⑫
Attention! Push lamp into nal position.
⑬
Test
Detailed information in the speci c instal-
⑭
lation instructions of the CANbus adpater
⑮
Print the certi cate
How to get general type approval (AGB) for
⑯
use in your vehicle on public roads
Scan the QR code on the top of the
⑰
packaging to authenticate the product and
download the certi cate.
EN
⑱
Print out the approval document (ABG).
⑲
Keep the approval certi cate(ABG) at all times with you in the vehicle.
In countries where applicable: paste the sticker on the headlight unit next to the
⑳
engine compartment / under the handlebar.
㉑
You are responsible to comply with all applicable legal requirements.
Approved for road tra c for selected countries and vehicle models only.
㉒
Check your country/vehicle at: Philips.com/roadlegalLED.
㉓
General guidelines
This LED replacement light source is only approved for right-hand tra c. Before
㉔
entering a country with left-hand tra c, the LED lamp must be replaced by a
halogen lamp.
㉕
Please check car installation manual and follow instructions for lamp replacement.
The LED light source, cables and components must be mounted in a way that
the headlamp won't be damaged and that its function is maintained. All parts
㉖
must be xed safely. Check correct position and safe xation of LED lamp within
the lamp holder.
The replacement of the lamp in the headlamp requires
㉗
inspection and eventually adjustment of headlamp setting by a quali ed garage.
㉘
General guidelines-Safety
The replacement of the halogen lamp by an LED light source may a ect the
㉙
deicing and defogging behavior of the headlamp.
The LED light intensity is very high while turned on. Do not look
㉚
directly into the beam to avoid damage to the eyes.
㉛
Please wear safety glasses while replacing halogen lamps.
Lamps will heat up during operation. Do not touch. Please let it cool down in order
㉜
to avoid potential injury due to contact with hot surface.
㉝
Please wear safety gloves to avoid injuries during mounting.
㉞
Keep out of reach of children.