Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
Pilot won't stay lit Dirt built up around pilot
Burner won't light Propane cylinder
Burner flame
is low
Carbon
build-up
or thick
black smoke
28 | www.bluesk youtdoorliving.com
POSSIBLE CAUSES
Connection between
gas valve and pilot
assembly is loose
Thermocouple is not
operating correctly
is frosted over
Blockage in orifice
Control knob is not
in ON position
Gas pressure is low
Outdoor temperature is
less than 40 °F (5 °C) and
tank is less than 1/4 full
Control knob fully ON
Dirt or film on reflector
and burner screen
Blockage in burner
CORRECTION ACTIONS
Clean dirt from around pilot
Tighten connection
and perform leak test
Replace thermocouple
Wait until the propane
cylinder warms up and
becomes unfrosted
Clear blockage
Turn control knob
to ON
Turn cylinder valve OFF
and replace cylinder
Use a full cylinder
Check burner and orifices
for blockage
Clean reflector and
burner screen
Remove blockage and clean
burner inside and outside
Publicité
