Blue Sky Outdoor Living PHPG8919B Manuel Du Propriétaire page 15

STEP 6
Attach the reflector [A] to the flame
screen [B]. Screw three studs [CC] into
the flame screen. Put three small flat
washers [BB] onto the studs, then put
the reflector onto the studs. Secure
with three flat small washers [BB] and
wing nuts [AA].
AA BB
STEP 7
WARNING
The black silicone ring must be in
place prior to operating the heater.
To aid in installation, place the black
silicone ring [F] in the hole on the
control box assembly [J].
Carefully install the glass tube [C]
by inserting it in-between the upper
supports and then angling it up so that
it can be lifted up into the center hole
in the flame screen [B].
Place the bottom end of the glass
tube into the hole in the control box
assembly [J]. Check and ensure that
the glass tube is positioned properly
and is completely covering the center
hole. Ensure the rim of the glass tube is
sitting firmly in the black silicone ring.
15 | www.bluesk youtdoorliving.com
A
CC
AA
BB
CC
B
B
C
J
F