Blue Sky Outdoor Living PHPG8919B Manuel Du Propriétaire page 27

• Use high-quality automobile wax to help maintain the appearance of your
heater. Apply to exterior surfaces from the pole down. Do not apply to
emitter screen or reflectors.
• Between uses, the heater should be stored with the control knob in the
OFF position and the LP source disconnected.
• The heater should be stored in an upright position in a sheltered area away
from direct contact with inclement weather (such as rain, sleet, hail, snow,
dust and debris).
• If desired, cover the heater to protect the exterior surfaces and help
prevent build-up in air passages. NOTE: Wait until the heater has
completely cooled to the the touch before covering.
• Only a qualified service person should repair gas passages
and associated components.
TROUBLESHOOTING
PROBLEM
Pilot won't light
27 | www.bluesk youtdoorliving.com
POSSIBLE CAUSES
Cylinder valve is closed
Blockage in orifice
or pilot tube
Air in gas line
Low gas pressure with
cylinder valve fully open
Igniter fails
CORRECTION ACTIONS
Open valve
Clean or replace
orifice or pilot tube
Open gas line and
hold down control knob
to bleed for not more
than 1–2 minutes or
until you smell gas
Turn cylinder valve OFF
and replace cylinder
Use match to light pilot
or replace igniter