Publicité
Les langues disponibles
Les langues disponibles
CARE AND MAINTENANCE
WARNING
Do NOT touch or move heater for at least 45 minutes after use.
The reflector and the glass tube are hot to the touch. Allow them
to cool before touching.
To enjoy years of outstanding performance from your heater, make sure you
perform the following maintenance activities.
• Use warm soapy water to clean exterior surfaces. Never use flammable
or corrosive cleaning agents. While cleaning your unit, be sure to keep
the area around the burner and pilot assembly dry at all times. Do not
submerge the control valve assembly. If the gas control is submerged in
water, do NOT use it. It must be replaced.
• Keep controls, burner and circulating air passageways clean and air flow
unobstructed. Check for spiders, insects and debris. Clean burner holes
by using a heavy-duty pipe cleaner. Compressed air may help clear away
smaller particles. Signs of blockage include a gas odor, extremely yellow
flame tips, low heater temperature, uneven glow or popping noises.
• Keep the ventilation opening(s) of the cylinder enclosure free and clear
from debris.
• Visually check the portions of the hose assembly located within the
confines of the heater post. Disassemble the reflector and burner and
inspect the entire hose assembly at least once a year for evidence of
excessive abrasion, cuts or wear. Suspected areas should be leak tested.
• Carbon deposits may create a fire hazard. Disassemble the reflector,
unscrew the reflector spacer, take off the screen and take down one side
of protective guards. Then take the glass tube from the heater. Wash until
clear, then dry completely. After that re-assemble.
• In a salt-air environment (such as near an ocean), corrosion occurs more
quickly than normal. Frequently check for corroded areas and repair them
promptly.
26 | www.bluesk youtdoorliving.com
Publicité
