Pelgrim BSSA670 Serie Notice D'utilisation page 49

OPERATION WITH A CONNECTED HOB
Making the connection between cooker hood and hob
The connection to an AutoAir hob is not active by default. First the
connection to the hob must be activated.
At the same time, a setting must also be made on the hob; see the hob
manual for this.
Check our website for the full range of hobs that can be connected to
your cooker hood.
Making a connection
1. Turn off the hood and the lighting.
2. Touch and hold the automatic mode key 3 for three seconds.
The automatic mode key, the lighting key, the timer key and the
filter indicator key will flash simultaneously for a maximum of two
minutes.
On your hob, activate the pairing mode in the user menu (see the
hob manual). The connection to the hob is established.
3. The connection is successful when the automatic mode key, the
lighting key, the timer key and the filter indicator key are illuminated
continuously for two seconds.
If the automatic mode key, the lighting key, the timer key and the
filter indicator key are no longer illuminated within two minutes, the
connection was not successful. Repeat the procedure. If necessary,
clear the hood's memory (see "Disconnecting").
Disconnecting
1. Turn off the hood and the lighting.
2. Touch and hold the filter indicator key 3 for three seconds.
The automatic mode key, the lighting key, the timer key and the filter
indicator key will blink five times simultaneously.
The hob is no longer connected.
EN 9