Publicité
Les langues disponibles
Les langues disponibles
cause the combustion engine to
start unexpectedly.
Risk of injury from the cutting
blade!
Pulling the starter rope spins the
work tool when the cutting blade
is engaged. When using the jumper
cable, make sure to always leave a
space sufficient distance between
the cutting blade and the user, in
particular at the level of the hands
and the feet.
Allow the device to cool down,
especially before working on the
combustion engine, exhaust
manifold and silencer.
Temperatures of 80°C or more can
be reached. Risk of burns!
Direct contact with engine oil can
be dangerous, do not spill engine
oil.
Only carry out maintenance work
that is described in this operating
manual, have all other work carried
out by a specialist dealer.
If you do not have the necessary
tools, or if you do not know enough
about the appliance, always
contact a specialist retailer:
info@eco-repa.com
For safety reasons, have the
condition and tightness of the
components checked regularly.
fuel supply system (fuel line, fuel
supply valve, tank, tank cap and
connections, etc.) and have them
replaced if necessary by a
specialist: info@eco-repa.com
IMPORTANT - Regular, careful
maintenance is essential for
keeping the safety level and
original performance of the
machine unchanged in time.
Keep all nuts, bolts and screws
tight to be sure the equipment is in
safe working condition.
Regular maintenance is essential
for safety and performance
Never store the equipment with fuel
in the tank inside a building where
fumes can reach an open flame ,a
spark or a source of extreme heat.
Allow the engine to cool before
storing in any enclosure.
To reduce the fire hazard, keep the
engine; exhaust silencer, battery
compartment and petrol storage
area free of grass, leaves, or
excessive grease. Do not leave
containers
with grass cuttings in doors.
Replace worn or damaged parts for
safety. For reasons of safety, do
not use the equipment with worn or
damaged parts. Parts are to be
replaced and not repaired. Parts
that are not of the same quality can
damage the equipment and be
dangerous for your safety.
If the fuel tank has to be drained,
this should be done outdoors and
when the engine is cool.
Wear strong work gloves when
removing and reassembling the
blade.
Check the blade's balance after
sharpening.
74
Publicité
