Publicité
Les langues disponibles
Les langues disponibles
Read and understand all safety information before connecting heater to propane tank.
1. Place heater onto tank with tank collar bracket over tank collar (Fig. 2). Mounting bolt knob should be
positioned to the outside of tank collar and be positioned as closely as possible
directly opposite to the cylinder valve outlet. See Figures 1 and 2.
2. Firmly secure to tank by hand-tightening mountingbolt knob. Do not overtighten mounting bolt knob.
3. Make sure heater regulator knob is in the (OFF) [
4. Insert regulator's connector into tank's valve outlet fitting and turn left (counterclock-wise) until fully tightened.
Threads are left-handed. (Figure 2.)
NOTE: Heater features a hand wheel that can be used to tighten the fitting to the cylinder. No
wrench is required, but may be used if desired.
NOTE: The vertical stem of this heater must be installed in the vertical position. This heater is
equipped with a safety shutoff switch in the event that the heater is tipped over during operation.
The heater may fail to remain lit if the vertical stem is not installed vertically.
5. Open propane tank valve slowly by turning counterclockwise
6. Check all fittings for leaks. Apply a 50/50 mixture of liquid soap and water to all joints. Bubbles forming
show a leak. Correct all leaks at once.
WARNING: NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
7. Always remove heater from propane cylinder after each use. Do not store heater while attached
to propane tank.
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
PROPANE TANK TOP HEATER
CONNECTING HEATER TO PROPANE TANK
] position.
.
8
Publicité
