Publicité
Les langues disponibles
Les langues disponibles
PROPANE TANK TOP CONSTRUCTION HEATERS
The heater is designed and approved for use as a construction heater under ANSI Z83.7, CSA 2.14.
It is hard to anticipate every use which may be made of this heater.
FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.
Other standards govern the use of fuel gases and heat producing products in specific applications.
Your local authority can advise you about these.
IMPORTANT: READ THIS USER'S MANUAL CAREFULLY AND COMPLETELY BEFORE TRYING
TO OPERATE OR SERVICE THIS HEATER. IMPROPER USE OF THIS HEATER CAN CAUSE
SERIOUS INJURY OR DEATH FROM FIRE, EXPLOSION AND CARBON MONOXIDE POISONING.
This is a direct-fired tank top construction heater for indoor construction use only. The heater must be placed
where it is NOT directly exposed to water spray, rain and/or dripping water. Its intended use is primarily
the temporary heating of buildings or structures under construction, alteration or repair. All the products
of combustion generated by the heater are released into the area being heated. This heater operates at
approximately 98%+ combustion efficiency but still produces a small amount of carbon monoxide. Humans can
tolerate small amounts of carbon monoxide for short periods. Carbon monoxide can build up in a heated space
and failure to provide adequate ventilation could result in poisoning or death.
PROPANE TANK TOP HEATER
SPECIFICATIONS
MODEL
TYPE
TT360L
MATCH
TT360DG
MATCH
TT360PDG
PIEZO
CHECK WITH YOUR LOCAL
cylinder)
40,000
40,000
40,000
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
3
Publicité
