Menu 5. Choose Probe; Menu 6. Stand-By Mode; Menu 7. Sound Mode; Menu 8. Initial Load - Bio Bronpi Radiofrequency Série Instructions D'installation, D'utilisation Et D'entretien

9.4.5 Menu 4. Select Language
It allows selecting the languages among those available. To access this menu you have
to confirm with button nº 7 and then, choose the selected language among available:
Spanish, English, French, Italian, German and Portuguese with buttons nº 1 and 2 (see
drawing D77).
9.4.6

MENU 5. CHOOSE PROBE

It allows us to select the probe to control the operation of the stove or insert (the one
in the equipment or the one on the remote control). It is advisable to select the option
"Internal probe (stove or insert probe)" so that the stove works depending on the
temperature where it is installed and not the temperature of the room where the remote
control is. See drawing D78.
9.4.7

MENU 6. STAND-BY MODE

The stove or insert with the "stand-by mode" activated (see drawing D79) will turn off
when the temperature reaches the temperature set plus a differential (2º C). When the
ambient temperature falls to the set temperature minus a differential (2ºC) the stove
automatically restarts an ignition cycle. It means that if you choose a set temperature
of 22ºC the stove wills turn-off when the room temperature is 24º C and it will restart
automatically when the ambient temperature falls to 20ºC.
In case of the "Stand-by Mode" is deactivated (by default) the stove will work in
"modulation work" when it reaches the set temperature and that allows the temperature
set could be higher.
9.4.8

MENU 7. SOUND MODE

By activating this modality, the stove or insert will emit a sound when the system detects
a fault and goes into the alarm state. To access to this menu you have to confirm with button nº 7 and then, choose
"on" with buttons nº 1 and 2 (see drawing D80).
9.4.9

MENU 8. INITIAL LOAD

In case of the stove have no more fuel during the operation, to avoid an anomaly in the next ignition, it is possible
to do a fuel pre-load for maximum time of 90 seconds to load the screw-type conveyor when the stove is switched
off and cold. To start the load press button nº 2 and to stop it press button nº 3. (See drawing D81).
It is very important that the burner is totally clean when you start the stove or insert. So, when the initial
load is finished, you must check the burner is clean of fuel to do correctly the ignition of the stove.
9.4.10

MENU 9. STOVE STATE

It shows up the current state of the stove or insert and provides information about the devices connected. Therefore, the user can get a
technical information. The next screens are seen automatically (see drawing D82, D83, D84).
29ºC
AMBIENT
1.0b
3.7
SPEED
STATE 5
OPERATIONAL
MENU
D82
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
99ºC
SMOKE
2600
SPEED EXTR.
STATE 6
OPERATIONAL
MENU
D83
41
Menu 05
Menu 04 SELECT
SPANISH SENSOR
MENU MENU
D77
ON ON
Menu 06 Menu 07
MODE MODE
STAND-BY SOUND
MENU
MENU
D79
76"
22º C
LOAD
INITIAL
MENU
10"
TIME-OUT
80"
TIME CLEANING
194 V RETE
00 A 19.7 V
FAN
CHARACTERISTICS
MENU
D84
RADIOFREQUENCY SERIES
D78
D80
D81