Replacing The Uvc Lamp; Wear Parts - Oase FiltoClear 3000 Notice D'emploi

- English -

Replacing the UVC lamp

• Remove the UVC unit head (See
Removing/inserting the UVC unit head).
A. Clean the quartz glass tube (19) externally
using a moist cloth.
• Undo the fastening screw (46) from the
retaining ring (45), and unscrew the
retaining ring.
• Remove the quartz glass tube including
the O ring (47).
B. Pull the UVC lamp (49) out of the lamp
base.
• Pull the transport securing elements
(48 and 50) from the UVC lamp and
push over the new UVC lamp.
• Insert the new UVC lamp.
C. Place the quartz glass tube (19) over the
UVC lamp (49) again.
• Push the O ring (47) and the retaining
ring (45) over the quartz glass tube.
D. Tighten the retaining ring by turning it up
against the stop (50).
• Tighten the fastening screw (46) for the
retaining ring.
• Reinsert the UVC unit head (See
Removing/inserting the UVC unit head).
• Switch on the pond pump.
• Connect the power plug of the UVC unit.
Storage/Winterization
• Disconnect power cord from UVC unit
• Disconnect hoses from inlet and outlet connections
• Empty/drain container by tipping unit on its side to let water drain out of inlet and outlet connection area
• If bypassing filter connect inlet and outlet hoses together to continue running pump in pond

Wear parts

The UVC lamp, the quartz glass and the foam filters are wear parts and are excluded from the warranty.
Disposal of UVC unit and UVC lamp
Do not dispose of this unit with domestic waste! Disable the unit beforehand by cutting off the cables. Further
information about the recycling of this product can be obtained from your local municipal authority.
Disposal of Packaging, Worn foam filters, sealing rings and Filter container
You may dispose of these components with domestic waste! Further information about the recycling of this product can be
obtained from your local municipal authority.
A
B
D
C
10