Connecting The Aquamax Eco Premium Pump To The 2" Outlet; Installing A Uvc Clarifying Unit In The Container - Oase ProfiClear Premium Individualmodul Notice D'emploi

- GB -
4.2.3

Connecting the AquaMax Eco Premium pump to the 2" outlet

The Individual Module offers space for installing two AquaMax Eco Premium filter pumps. In this case,
the second filter pump has to be turned through 180° in relation to the other pump and installed slightly
offset to the rear. The filter pumps are connected to the 2" outlets. The 2" hoses used for the connection
should be connected to the filter pumps via a connection bend.
For the filter pump offset to the rear: Connect the 2" hose directly to the inside hose connector of the 2"
outlet without using a second connection bend.
For the front filter pump: Connect a short connection hose with a second connection bend to the 2"
outlet.
OASE recommends the 2" connection bend, Order No.: 50540.
How to proceed:
4.
L
1. Fit the O ring onto the outlet.
2. Fit the outlet into the respective hole of the container wall from the outside.
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
−
3. Fasten the outlet from the inside with oval head screws.
4.3

Installing a UVC clarifying unit in the container

A maximum of two Bitron Gravity UVC clarifying units can be installed in the container of the
►
Individual Module in conjunction with two AquaMax Gravity Eco pumps. Please refer to the Bitron
Gravity operating manual for information about installation.
24
19397-07-13_GA_ProfiClear_Premiu24 24 25.07.2013 11:48:40