Installation And Connection - Bartscher 150524 Mode D'emploi

•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not move or tilt the device when in operation.
•
Never leave the device unattended when in use.

5.2 Installation and connection

•
Unpack the device and remove all packing material.
•
Put the device in a safe place that can support its weight and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface.
•
Never place the device at the edge of a table to avoid accidents.
•
Never put the device in a moist or wet area.
•
Do not place the device near an open flame, electric heater or other heat source.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect
the device if the need arises.
•
Insert the power cable into the rice cooker, then insert the plug into an outlet.
Ensure that no one trips over the power cable.
- 25 -