Installation And Operation; Safety Instructions; Installation And Connection - Bartscher A100155 Mode D'emploi

5. Installation and operation

5.1 Safety instructions

•
Never allow the power cable to come into contact with heat sources or sharp edges.
The power cable should not hang over the side of the working surface. Ensure that no
one can step on or trip over the cable.
•
The power cable must not be folded, bent or tangled, and must always remain fully
unrolled.
•
Never place the device or other objects on the power cable.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not move or tilt the device when in operation.
•
Never use the device with wet or moist hands.
•
Never leave the device unattended when in use.

5.2 Installation and connection

•
Unpack the device and remove all packing material.
•
Put the device in a safe place that can support its weight and is not heat sensitive.
•
Never place the device at the edge of a table to avoid accidents.
•
Never put the device in a moist or wet area.
•
Do not place the device near an open flame, electric heater or other heat source.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
The device must only be connected to a properly installed single socket with
protective contact.
Never remove the power cable by pulling the cable itself; always grab the plug
housing.
- 22 -