Publicité
Les langues disponibles
Les langues disponibles
12
TIP: Insert a small length of duct over the 3¼" x 14" damper assembly and seal the joint using
NON-DUCTED INSTALLATION ONLY
7 ] Remove 3 screws retaining the recirculation cover plate to the hood. Discard this plate
with its screws. Peel off and discard the membrane covering the recirculation grille,
ensuring the openings are totally cleared.
SCREWS
RECIRCULATION
COVER PLATE
3¼" x 14" DUCTED INSTALLATION ONLY
8 ] Remove 3¼" x 14" vertical or 3¼" x 14" horizontal knockout plate as appropriate for
your ducting method (see F
F
1 A
IGURE
3¼"
14"
X
VERTICAL
KNOCKOUT
PLATE
9 ] Assemble the 3¼" x 14" frame (removed in step 2) with the damper flap (removed in step 4)
by following the instructions provided on a separate sheet. Attach the 3¼" x 14" Damper
Assembly on top OR back of hood over the knockout opening using the screws removed in
step 2. When installed, the 3¼" x 14" damper assembly must open as shown in F
F
2 A
IGURE
SCREWS
SCREWS
aluminum foil duct tape to ease connection with the house ductwork.
1 A and 1 B).
IGURES
F
1 B
IGURE
3¼"
14"
X
HORIZONTAL
KNOCKOUT
PLATE
F
2 B
IGURE
3¼"
14"
X
DAMPER
ASSEMBLY
3¼"
14"
X
DAMPER
ASSEMBLY
DAMPER
FLAP
TOP/BACK
PIVOT
EDGE OF
HOOD
BACK OF
HOOD
DAMPER
FLAP
PIVOT
2 B.
IGURE
Publicité
