Publicité
Les langues disponibles
Les langues disponibles
USE
Button Function
A
Turns the suction motor on and off at speed one.
B
Decreases the working speed.
C
Increases the working speed.
D
Activate intensive speed from any other speed,
including motor off. This speed is set to operate for 6
minutes, after which the system returns to the speed
that was set before. Suitable to deal with maximum
levels of cooking fumes.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
On and Off.
E
24H function
Turns the suction motor on at speed one and effects
one 10 minute extraction every hour.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for
approximately 3 seconds.
These indications are only visible when the motor is
turned off.
F
Delay function
Activate automatic switch-off with a 30' delay.
Suitable to complete elimination of residual odours.
Can be activated from any position, and is disabled
by pressing the button or turning the motor off.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote Control On and Off.
G
Turns the lighting system on and off at maximum
intensity.
H
Turns the Courtesy Lighting on and off.
EN
Control panel
Display
Displays the set speed
Displays the set speed
Displays the set speed
Displays HI and the time remaining once very second.
FC+Punto (2 flashes)–Alarm On.
FC+Punto (1 flash)–Alarm Off.
Displays 24 and the spot at the bottom right flashes
once every second, while the motor is running.
It is disabled by pressing the button.
FF flashes three times.
When the procedure terminates, the indication shown
previously turns off:
FG indicates the need to wash the metal grease
filters. The alarm is triggered after the Hood has been
in operation for 100 working hours.
FC
indicates the need to change the activated
charcoal filters, and also to wash the metal grease
filters. The alarm is triggered after the Hood has been
in operation for 200 working hours.
Displays the operating speed and the spot at the bottom
right flashes once a second.
IR+Punto (2 flashes)– Remote Control On.
IR+Punto (1 flash)– Remote Control Off.
2
24
Publicité
