Télécharger Imprimer la page

Jennair JBSFS48NMX Instructions D'installation page 15

Masquer les pouces Voir aussi pour JBSFS48NMX:

Publicité

Les langues disponibles

Les langues disponibles

PLUG IN REFRIGERATOR
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similar
qualified person. Do not use a cord that shows cracks or
abrasion damage along its length or at either the plug or
connection end.
1.
Set control switch at top of cabinet to the OFF
position.
2.
Plug into a grounded 3 prong outlet.
INSTALL SIDE TRIMS
The side trims cover the space between the refrigerator
and the adjacent cabinets. There is a trim piece taped to
each side of the refrigerator. Install each trim piece to the
side of the refrigerator to which it is taped.
1.
Remove the tape attaching the trim pieces to the
sides of the
refrigerator. Set the trim pieces aside.
2.
Remove the four screws from the side of the
refrigerator
cabinet.
A
A. Side trim screws
3.
Using the original holes and the screws removed in
Step 2,
fasten the side trim to the refrigerator cabinet.
NOTE : Make sure to fasten each trim piece to the
side of the refrigerator cabinet from which it was
removed. The tapered shaped edge should be
forward with the notches aligning with the door
hinges.
TOP VIEW
C
A. Side trim
B. Adjacent cabinet
MOVE REFRIGERATOR TO FINAL
LOCATION
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT :
 A flush installation is NOT possible with a 24" (60.9
cm) deep opening.
 To avoid floor damage, make sure levelers are raised
(not touching floor) and refrigerator is on rollers
before moving.
 Use the installation block, attached to the door hinge,
as a reference to make sure the refrigerator is pushed
back far enough into the opening, so that when
the panels are installed they will be flush with the
adjacent cabinets.
A
B
C. Door
15

Publicité

loading

Ce manuel est également adapté pour:

Jbsfs42nmx