Jennair JBSFS48NMX Instructions D'installation page 12

STAINLESS STEEL PANEL KIT
INSTALLATION REQUIREMENTS
Refer instructions received with full height door panel kit.
UNPACK THE REFRIGERATOR
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT :
Do not remove the film covering until the refrigerator
is in its operating location.
All four leveling legs must contact the floor to support
and stabilize the full weight of the refrigerator.
Keep the cardboard shipping piece or plywood under
the refrigerator until it is installed in the operating
location.
1.
Remove and save the literature package and
hardware kit located inside the refrigerator. Remove
and save the literature, grille, and trim taped to the
outside of the refrigerator.
NOTE : Do not remove tape and door bracing until
the refrigerator is in its final location.
MOVE THE REFRIGERATOR INTO HOUSE
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
12
INSTALLATION INSTRUCTIONS
CUSTOM WOOD PANEL DIMENSIONS
AND INSTALLATION REQUIREMENTS
Refer instructions received with Armoire kit.
1.
Place an appliance dolly under the left side of the
refrigerator as shown. Place the corner posts from
the packing materials over the trims as appropriate.
Slowly tighten the strap.
2.
Place pieces of the shipping carton on the floor when
rolling the dolly and refrigerator into the house. Move
the refrigerator close to the built-in opening.
3.
Place top of cardboard carton or plywood under
refrigerator. Stand the refrigerator up. First, place the
left bottom edge of
the refrigerator upright and then lower the
right-hand side of the refrigerator to the floor.
4.
Reassemble the trim and top grille after the dolly has
been removed from the refrigerator.
CONNECT THE WATER SUPPLY
Read all directions before you begin.
IMPORTANT :
If you turn the refrigerator on before the water line is
connected, turn the ice maker OFF.
Connect to potable water supply only.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
CONNECT TO WATER LINE
PARTS NEEDED
Minimum 7 ft (2.13 m) flexible, codes-approved water
supply line.
the refrigerator on the floor, stand