Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
INPUT
Use a quality instrument or patch cable with 1/4" plugs to connect
your guitar or the output of another effects pedal to this jack.
7
9V DC INPUT
For mains operation, connect an optional 9 Volt DC power adapter to
this barrel style jack. Please refer to "POWER REQUIREMENTS" for
details.
8
PAD SWITCH
Attenuates the pedal's input sensitivity to prevent distortion when
used with high output active bass guitars. Select the position that
best matches your instrument.
9
OUTPUT
Use a quality instrument or patch cable with 1/4" plugs to connect
this jack to the input of your amplifier or that of another effects
pedal.
10
10
10
INSERTING/REPLACING A BATTERY
The Battery is of the 6LF22 blocktype (9Volts). A quick access
comparement for easy battery replacement is located at the bottom
of the unit. Always remember to unplug your guitar cord from the
Input of the pedal to prolog battery life. Some battery drain may
occur when the unit is plugged in, even if it is bypassed.
1
Pull the holder
2
Open the cover
3
Insert the battery
(observe correct polarity) the battery
4
Close the holder
POWER REQUIREMENTS
• Battery: Standard 9V battery
• Power consumption: approx. 15 mA
• Power supply:
9 V DC (regulated) 50 mA minimum
5.0 x 2.1 mm barrel style connector center negative
ATTENTION: Please use a DC power supply or battery only!
Failure to do so may demage the unit and void the warranty.
1
4
3
2
11
11
11
Publicité
Table des Matières
