Panel Description - Palmer Root Effects UNTERTON PEBUNT Manuel D'utilisation

PANEL
1
HIGH
7
8
8 8 8
ON
2 4
3
BLEND MOD LOW
6
5
10
9

PANEL DESCRIPTION

1
HIGH CONTROL
Adjusts the balance between the octave up and octave down sounds
that are mixed in with the blend control (2). Turning this control
clockwise also adds dirt and fuzz to your sound.
NOTE: This control is only active when the MOD button (3) is
pressed which deactivates the LOW control (4).
2
BLEND CONTROL
This is a classic wet/dry pot. Adjust the mix between the effected
and the unprocessed signal.
3
MOD SWITCH
When this button is pressed, the LOW filter is deactivated.
4
LOW CONTROL
Adjusts the sound one octave below the original that is mixed
in with the blend control (2). Turning this control clockwise
increases the octave down content.
NOTE: This control is only active when the MOD button (3) is not
pressed.
5
ON / OFF SWITCH
Activates the effect or switches the pedal to bypass mode.
6
LED STATUS INDICATOR
Lights when the effect is switched on. This LED also doubles as
battery level indicator when the pedal is battery powered. When the
LED goes dim or no longer lights while the effect is activated the
battery is drained and needs replacing.
9 9 9