Magmaweld monoSTICK 200i Mode D'emploi page 11

monoSTICK 200i
TECHNICAL INFORMATION
1.1 General Information
monoSTICK 200i is an inverter type portable, mono-phase DC MMA welding machine designed to weld stick
electrodes up to 4 mm. Even though the machine is mono-phase, due to the inverter technology it provides
stable arc and good re-striking performance, also the electric consumption is approximately 10% less than
the silicon controlled rectifier equipments and 25% less than the magnetically controlled equipments.
monoSTICK 200i proved well that it can work between 185 to 250 V 50/60 Hz line voltages. Therefore this
machine is quite immune to mains voltage fluctuations and perfectly welds with generator-sets.
monoSTICK 200i can also be used with long welding cables up to 25 mt. The machine is fan cooled and
thermally protected against over heating.
1.2 Machine Components
1
2
3
4
1- Handle
2- Thermic / Error Led
3- Current Adjustment Pot
4- Earth Cable and Welding Cable (-) 9- Power Switch
5- Power Led
www.magmaweld.com
5
7
8
6
6- Earth Cable and Welding Cable (+)
Figure 1: monoSTICK 200i
7- Fan
8- Line Cable Inlet
Technical Information 11
9
USER MANUAL
EN