Vivobike E-2500 RM Mode D'emploi Et D'entretien page 5

1. Tyre & tubes
2. Rims
3. Spokes
4. Front hub
5. Front fork
6. Front disc-brake
7. Front mudguard
8. Handlebar & stem
9. Bell
10. Frame
11. Pedal
12. Crank set
14. Seat clamp
Instruction
THE "EXTRAORDINARY" MAINTENANCE OF THE MECHANICAL AND ELECTRICAL COMPONENTS MUST BE
PERFORMED BY A QUALIFIED TECHNICIAN.
Ⅲ. MANUAL FOR THE ELECTRIC PARTS
The rider must pedal forward to obtain any assistance from the motor. This is an important safety feature.
This electric pedal assistance bikes will provide assistance up to 25 Km/h, after that the motor will cut out.
You may go faster but must do so under your own effort without the electric assistance.
To start the bike turn on the main switch on the side of the battery, the LED on the handlebar panel will
light up. The motor will not work until you pedal one/two full revolution of the chain wheel. This feature
protects the motor and controller from damage and extends the service life of the electric components.
Contents
1. Structure of an electric assistance bike
2. Important safety cautions
3. Operation
4. Battery installation & usage
5. LED and function
6. Using and maintaining the battery
7. Using and maintaining the charger
8. Using and maintaining the electric hub motor
9. Maintaining the controller
10. Maintaining the Power-off control of the brake lever
11.. Simple troubleshooting
12. Electric circuit diagram and specifications
13. Main technical specification sheet
15. Seat post
16. Saddle
17. Chain
19. Rear derailleur
20. Freewheel
21. Kickstand
22. Rear motor hub
23. Rear mudguard
24. Rear carrier
25. Battery
26. Grip, shift lever & brake lever
27. Brake, shift and display cables
28. Power display
5/44