KitchenAid 4318635 Instructions D'installation page 10

keyholes
keyholes
11
I with strews at thes
15
. Tighten top mounting panel
assembly to refrigerator with screws.
Use two plastic nuts to reattach
tethers to mounting panel assembly.
Insert decorative panel into keyholes
in mounting panel assembly. Pull
down to secure.
16
. If side panels are not used,
go to Step 17.
If built-in area depth is 25"
(63.5 cm) or more, side panels can
be installed inside the side trim or
attached to the outside of the side
trim:
wall
support board
l
Inside side trim piece: Slide front
edge of routed side panel into trim
piece. Nail rear edge of panel to
support board.
l
Outside side trim piece: Drill 6
equally spaced holes into side trim
piece. Do Not drill into side of
appliance. Attach a support board
to trim piece. Nail front and rear
edges of side panel to support
boards. Cover front support board
with a matching panel piece.
If built-in area depth is less than 25"
(63.5 cm), complete side panel
installation according to site
restrictions. (One method is to install a
support nailer on the built-in opening
rear wall. Drill holes into side trim. Then
attach wood support to trim. Attach
side panel to wood support and
support nailer. Cover wood support
with a matching panel piece.)
. Open appliance doors and
18
. Set refriaerator and freezer
compartment controls to the
midpoint between "COLD" and
"COLDEST." Check that the
compressor is operating properly and
that all five lights are working.
remove protective film from door
frame. Recheck water connections at
bottom of refrigerator for leaks.
Attach bottom grille to cabinet with
two screws. Install shelves and bins in
refrigerator and freezer
compartments.
Part No. 2001094 Rev. A
0 1993 KitchenAid.
@ KitchenAid. Registered trademark
of KitchenAid.
@ Printed on recycled paper.
10% post consumer waste/
50% recovered materials.
Printed in U.S.A.