Publicité
Les langues disponibles
Les langues disponibles
FCC RF Exposure Information
• Read this information before operating the device.
In August 1996, the Federal Communications Commission
(FCC) of the United States, with its action in Report and Order
FCC 96-326, adopted an updated safety standard for human
exposure to radio frequency (RF) electromagnetic energy
emitted by FCC regulated transmitters. Those guidelines are
consistent with the safety standard previously set by both U.S.
and international standards bodies.
The design of this device complies with the FCC guidelines and
these international standards.
Body-worn Operation
This device was tested for typical body-worn operations with
the back of the device kept 0 cm (0 inches) between the user's
body and the back of the device.
FCC Part 15 Class B/IC RSS-Gen Compliance
This device complies with part 15 of FCC rules and ISEDC
license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Part 15.105 statement
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference with
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference or television
reception, which can be determined by turning the equipment
off and on, you can try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
7
Publicité
