Eurosystems SCR01 Mode D'emploi page 16

height for 1,5 mm. Considering the indications shown on the label (E) please check the index shifting (F) to realize to which direction you have to
turn the knob.
NB: Make the blades to enter into the earth by about 3-5 mm
Transfer configuration : lower the tool raising lever (3) to position B. This way the blades are not touching the ground.
STARTING AND STOPPING (Fig. 5)
Caution! Before operating the mower check:
a – the lever for the tool insertion (2) to be on A position.
b – the fuel tank to be full
c – the motor oil level to be correct. (please look at the engine instructions booklet).
d – in case you have the grass bag, please check it is correctly tightened.
Go on with the switching on according to what is described into the instructions booklet you can find with the engine.
After the engine switching on, move the accelerator lever so that you can reach the RPM you need.
Move the safety device (9) towards the direction shown by the arrow, then pull the tool insertion lever (2) on B position grasping the handlebar (3) at
the same time.
Pull the tool insertion lever (2) on B position grasping the handlebar (3) at the same time. Go on pushing the scarifier on the lawn following the direction
shown on the arrow fig. n. 1.
Stop : release the tool insertion lever (2) and bring the accelerator control on STOP position.
INSTRUCTIONS FOR MAINTENANCE AND STORAGE
Check the nuts, bolts and screws are tightened.
Be careful when making adjustments : danger of injury does exist. Do not clamp fingers between housing and blade. Wear protective gloves.
Please perform the adjustments as shown in paragraph : ADJUSTMENTS.
Check regularly to ensure that the grass box (optional) to be in satisfactory conditions
For safety reasons damaged and/or worn down parts should be immediately replaced.
The blades should be replaced when their length is less than 120mm.
Replacement blades and accessories should be original only to guarantee the safety and functionality of the unit.
Never store the scarifier with fuel into the tank inside a building where fuel vapours may come into contact with open flame or sparks : danger of
explosion !
Empty the fuel tank outdoors only. Let engine cool down before storing it in an enclosed room.
To prevent danger of a fire keep the engine and exhaust clear of grass leaves and leaking grease (oil).
ASSEMBLY OF GRASS BOX (OPTIONAL) Fig. 6
Insert metal frame (1) into cloth-bag (2). Fix it inside clamping rims of cloth-bag by means of a simple rounded-off toll-a spoon handle, for A,B,C,D, E
and F. Now you have to lift the scarifier rear cover (3) and insert the hooks (4) into the pins (5). Complete the tightening operations lowering the cover
9
(3) and making attention the bag handle ends (6) to enter the cover slots (7).