Montarbo T10A Manuel D'instructions page 9

Control and connection panel
4 3
1 IN: balanced input, fitted with a Neutrik Combo
which accepts both 3 pin XLR and jack plugs.
☛ See 'connectors' and 'connections' at pages 26 and 27,
and 'applications at pages 28 and 29.
2 OUT: balanced output, (in parallel with the input), using a 3 pin
XLR connector. It allows for easy parallel connection of other T10A
or active systems.
☛ See 'connectors' and 'connections' at pages 26 and 27,
and 'applications at pages 28 and 29.
3 MASTER LEVEL: it is the master volume control.
Adjusts the input levels of the 2 built-in power amplifiers to adapt
them to the output level of the mixer. It also allows to adjust the
speaker volume when this system is used in parallel with others.
Typical operating setting is on maximum position.
The trademark Neutrik Combo ® is property of Neutrik
1 2
connector 4 H.F. LEVEL: High frequencies level control.
®
Note: if you are using a Montarbo mixer (or any mixer having
an output level of 0dB), for optimum performance it is
advisable to set both the MASTER LEVEL and the H.F. LEVEL
controls fully clockwise (to their maximum settings).
5 POWER /0 - I: Mains power on/off switch.
6 Mains power cord socket (with built-in fuse).
Use only the factory supplied mains cable or a suitable cable with
a ground connection and marked with the safety approvals valid
in the country of use.
When installing make sure that it is easy to get to this connector
and to the mains plug.
2-way, bi-amplified, active loudspeaker system
T10A
9
ENGLISH