Garland APACHE 1275 ZSL Manuel D'instructions page 48

English
lawnmower to and from the area to be cut.
Do not go near the machine's cutting
D D ANGER ANGER
DO NOT USE MOWER WITHOUT ENTIRE
tool when it is running. Danger! Risk
GRASS CATCHER OR DEFLECTOR IN PLACE
KEEP HANDS and FEET AWAY
of finger amputation.
Keep hands and feet away from the blades.
Do not solely rely on the security features of this
machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine.
If you detect any anomaly immediately stop the
machine and check it carefully.
In case of mechanical failure take the machine to the
technical service for repair. You should not continue
working if you notice that the operation is not correct.
Remember to always use the machine with clean
hands and without any fuel or oil remains.
Clean the work area and remove all obstacles that
may cause accidents. Check the work area when
going to work and remove all items that could
become entangled in the cutting tool. Also remove
all the objects that the cutting tool can violently eject
while in operation.
Do not allow anyone to enter the work perimeter.
This work perimeter must be 15 meters and is a
danger zone.
You must turn off the engine when you are moving
between work areas.
Never leave this machine unattended.
Be careful not to touch the hot parts of the
machine while the engine is running or after
use, such as exhaust, spark plug or high voltage
cables.
Do not use other accessories this machine except
those recommended by our company since its use
could cause severe damage to the user, people close
to the machine and the machine itself.
Always follow the safety rules given in this manual.
7.1. HOLDING AND GUIDING THE MACHINE
While working, always hold the
lawnmower with both hands on the
handlebar.
Stand behind the mower and direct it while walking
behind it.
This lawnmower is self-propelled. Do not push the
mower; allow it to continue at its speed and limit
yourself to directing the machine in the work area.
Choose the most convenient setting according to the
type of work.
7.2. ADJUSTING THE CUTTING HEIGHT
WARNING! Stop the machine and wait until the
blade stops before proceeding to adjust the height.
Blades need a few moments to stop completely after
you turn off the engine.
48/184