Leds Display; Relay Mode / Bus Mode Jumper - RISCO Group WatchIN RK325DT Guide D'installation

LEDs Display

LED State
Steady
YELLOW
Flashing
Steady
GREEN
Steady
RED
Flashing
Flashing (One after
All LEDs
another)
Notes:
1. DIP-Switch 1 should be in ON position to enable LED indications.
2. Only one LED is active at any one time. For example, in the case of both PIR and MW detection, either the
steady YELLOW LED or the steady GREEN LED is displayed (the first to detect), followed by the Alarm RED
LED.

Relay Mode / BUS Mode Jumper

J-BUS jumper (located on the PCB between the red and green LEDs)
is used to define the detector's mode of operation as follows:
8
Description
Indicates PIR detection
Indicates AM (Anti mask) detection
Indicates MW detection
Indicates ALARM
Indicates malfunctioned communication with ProSYS (BUS
mode only)
Unit initialization on power up
WatchIN Installation Manual
Relay BUS
Mode Mode