Configuring The Watchin Dt Parameters - RISCO Group WatchIN RK325DT Guide D'installation

1. To Add / Delete the WatchIN DT
1. From the installer menu enter the Add/Delete menu: Quick Key [7][1][9][5] for BUS Zones
detectors.
2. Use the
ID number for which you want to assign (or delete) a detector.
Note:
Make sure that the detector's physical ID number is identical to the ID number you select during programming.
3. Place the cursor on the TYPE field and use the
WatchIN DT detector.
4. Press
5. Repeat the process for the other BUS detectors.
2. Assigning the WatchIN DT to a Zone
1. From the main installer menu enter Zones: One by One option (Quick key [2][1])
2. Select the zone number that you want to assign the BUS detector.
Note:
If you have defined a BUS Zone Expander, select a zone number from the virtual zones (defined by the BUS
zone expander).
3. Define Partitions, Groups, Zone Type and Zone Sound.
4. In the Termination category select [5] BUS Zone followed by
The following display appears:
Z:001
ID:01 TYPE=IDT25
5. Select the BUS zone number to assign to the programmed zone. The type field will be
updated automatically when selecting the zone.
6. Press
the following display appears:
Z:001 Z:001
N/A-BUS ZONE N/A-BUS ZONE
7. Press

Configuring the WatchIN DT Parameters

1. To access the WatchIN settings option press [2][0][3] from the main installer menu. The
following display appears:
B- ZONE PRMS: -
ZONE#=001
2. Select the zone that the BUS zone was assigned to and press
now program the WatchIN parameters as follows:
Zones Miscellaneous: BUS Zone
Quick Keys Parameter
[2][0][3][zzz] LEDS
[1]
Defines the LEDS operation mode
[2][0][3][zzz] Off
[1][1]
Disables the LEDS operation
[2][0][3][zzz] Red Only
[1][2]
Only the Red led will operate. This option is highly recommended to avoid the
18
/ or
/ to confirm.
LINK TO:
/ . The loop response category is not applicable to a BUS zone and
RESPONSE: RESPONSE:
/ , assign label and press
(0:01)
WatchIN Installation Manual
/ keys to position the cursor over the BUS Zone
/ key to select IDT25 for the
/
/ .
/
Default
3 LEDS
.
. You can