Publicité
Les langues disponibles
Les langues disponibles
3
INSTALLATION INSTRUCTIONS
3.8.2
Power Metering products online at:
Installation of Voltage Input Wires
1. Depending on the branch circuit, in-line fuses may be required by local
electrical codes.
2. Connect wiring for Line voltages and Neutral to the appropriate locations in the
breaker panel in accordance with all national and local electrical codes; see
Figure 4 for wiring diagram. Table 2 lists the voltage inputs.
3. The power source of the meter must be the same as the power source of the
load that the meter is measuring.
4. Trim the wire to the appropriate length to avoid coils of excess wiring.
5. Strip wiring to 0.3 inch if needed and connect to the appropriate terminals.
Voltage Inputs
Description
L1
Voltage Input, Line 1 Black Wire (Required)
L2
Voltage Input, Line 2 Red Wire
N
Neutral input, White Wire (Required)
Note: In-line fuses recommended
Figure 4 - Voltage Wiring Diagram
PowerMeterStore
www.
Table 2 - Voltage Connections
8
1.888.610.
.com
Publicité
