Suncast BMS6284 Instructions D'assemblage page 13

Assembly Walls
( continued)
Tilt right back panel (D) and right side panel (C) back into the upright position
(lowering the back right panel tabs into the slots of floor (A). The back right panel
tabs will ' snap' into place when in correct position.
Note: Left side panel not shown for clarity.
Secure back panels (E, D) together using three easy
bolts (EE) and working from bottom to top. Use easy bolt
easy driver (FF) to hand tighten. Easy bolt head will be
flush when fully seated. Do Not over tighten easy bolts.
Note: Top easy bolt location will be installed in a later
step.
13