Publicité
Les langues disponibles
Les langues disponibles
DONOTassemble theductwork w ith
screws orfasteners thatextend intothe
duct.They willserve asan
accumulation point f orlint.
Joints should besecured with
aluminum tape.
Alljointsshould betightto avoid leaks.
Themale endofeachductsection
mustpointaway fromthedryer.
Whether connecting to anexisting
venting system ora newventing
system, m ake surethatallducting is
clean andfreeof lint.
Themaximum permitted l ength forboth
rigidandflexible metal d uctisshown in
thetablebelow.
Number of Rigid D uct
Flexible Duct
90 °
Turns
or Elbows
0
66 ft.
45 ft.
(2011 cm)
(1372 cm)
1
56 ft.
36 ft.
(1707cm)
(1097 cm)
2
48 ft.
29 ft.
(1463cm)
(884 cm)
3
39 ft.
22 ft.
(1189cm)
(671 cm)
4
3Oft.
16 ft.
(914cm)
(488 cm)
Note:
Side and bottom exhaust installations
have a 90° turn inside the dryer. To
determine maximum exhaust length,
add one 90 °turn to the chart.
More than two 90 ° turns are not
recommended. For best performance,
separate all turns by at least 4 ft. of
straight duct, including distance
between last turn and exhaust hood.
Good
Better
Exhaust
vent hood
The exhaust duct must end with an
approved exhaust vent hood with
swing out damper(s). DO NOT use an
exhaust vent hood with magnetic
latches.
To avoid exhaust restriction, the outlet
must be a minimum of 12 inches (30
cm) above ground level or any other
obstructing surface.
Required
parts
The parts required for the exhaust air
system (elbows, lines, exhaust air
outlets) are not included in standard
delivery of the dryer.
Accessories
The parts required for the exhaust air
system can be obtained from customer
service or your local dealer. Please
follow the installation instructions
supplied by the appropriate
manufacturer!
;ide exhaust
kit
part no. WTZ 1265
Note:
The maximum permitted number of 90°
elbows (including this side exhaust kit)
is four!
[_
Special tool for cutting the hole in
prepared side panel is required.
Contact local dealer!
Bottom
exhaust
kit
part no. WTZ 1270
Note:
The maximum permitted number of 90°
elbows (including this side exhaust kit)
is four!
Dryer rack
part no. WTZ1290
Use the dryer rack to dry washable
woolen textiles (e.g. sweaters) and
shoes.
Left hinge kit
part no. WTZ 1260 for all dryers except
silver and duo tone silver
part no. WTZ 126S for silver and duo
tone silver dryers
The door catch can be reversed if
necessary. The door is hinged on the
right at the factory.
Pedestal
Mounting
Kit
part no. WTZ 1295 (White Dryers)
part no. WTZ 1295S (Silver Dryers)
part. no. WTZ 1295P (Duo tone Silver)
part. no. WTZ 1295R (Duo tone Red)
If mounting the dryer on the pedestal
follow the instructions supplied with the
pedestal.
Publicité
