Publicité
Les langues disponibles
Les langues disponibles
This deposit can easily be removed by
wiping the sensors (the two bars next
to the lint filter) with a cloth and a little
white vinegar.
Use white vinegar only!
Clean the moisture sensor once a
month.
Cleaning the bearing
shield
Over time, fluff from the drying process
collects in the bearing shield.
This fluff can be easily removed using
your vacuum cleaner, at least once a
month.
Change the light bulb
The dryer light turns on inside the drum
when you open the door.
To change the light bulb:
Set program selector to "Off".
Turn off the circuit breaker.
Pull out power supply plug.
Open the door and locate the light
bulb on the upper left side of the
seal.
Loosen the screw of the cover and
open the cover.
Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
Replace the cover and secure with
the screw.
Plug in dryer or reconnect power
supply.
19
Publicité
