Publicité
Les langues disponibles
Les langues disponibles
en
Setting the operating
temperature
(Fig. 2)
The operating temperature is regulated by the
temperature control.
Warm
1
2
1 = Lowest cooling setting (Warmest setting)
MAX. = Highest cooling setting (Coldest and
fast freeze option setting)
Please choose the setting according to the
desired temperature.
The interior temperature also depends on
ambient temperature, the frequency with which
the door is opened and the amount of foods
kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended to close
the door again as soon as possible after use.
The normal storage temperature of your
appliance should be -18 °C (0 °F). Lower
temperatures can be obtained by adjusting
the thermostat knob towards Position MAX.
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.
Cold
3
4
MAX.
Indicator lights
There are three coloured indicator lights located
inside the appliance which show the operating
mode of the freezer.
Amber Indicator
Illuminates when the thermostat knob is turned
to MAX. position and stays on until the fast
freeze operation is deactivated manually.
Fast-freeze operation is for freezing fresh food.
Green Indicator
Illuminates when the appliance is connected
to the mains and will glow as long as there is
electricity present. The green indicator does
not give any indication of the temperature
inside the freezer.
Red Indicator
Illuminates
a. When the appliance is first switched on,
and will stay on until the pre-set temperature
has been attained.
b. If the appliance is overloaded with fresh
food.
c. If the appliance door is left open accidentally.
Thermostat knob
The thermostat knob is located on the indicator
light frame.
Important:
When you press the fast-freeze switch or
adjust the set temperature, there may be a
short delay before the compressor starts to
operate. This is normal and not a compressor
fault.
4
en
Publicité
