Water Ace RTS5-01 1/2 HP Manuel D'utilisation page 8

Process C, continued.
Cement as many couplings and
STEP
sections of rigid PVC pipe on both
5
the pressure and delivery sides as it
takes to equal the depth of your well
minus four feet, then firmly clamp
the assembly with a pipe clamp to
prevent the assembly from sliding
down into the well. Be sure to keep
track of which pipe is the pressure
pipe and which is the delivery pipe.
Remove pipe clamp and slide well
STEP
seal RWS4-1012 over PVC pipes
6
and onto well casing. DO NOT let
assembly slide down into well.
Position assembly so that twelve
inches of PVC pipes protrude from
well seal. Using crescent wrench,
turn bolts on well seal clockwise
until rubber gaskets are tight
against the well casing and the PVC
pipes.
Cut 1" pipe 2" shorter than the
STEP
1-1/4" pipe. Smooth rough
7
edges. Cement 1" and 1-1/4"
PVC elbows to pipes protruding from
the well seal.
Thread a 1-1/4" male PVC adapter
STEP
into top hole in front of pump.
8
Thread 1" x 4" nipple into bottom
hole in front of pump. Thread the
1" female PVC adapter onto the 1"
x 4" nipple.
STEP
9
Cement as many
sections and
couplings of
rigid 1" and
1-1/4" PVC as needed to connect the 1" female PVC adapter and
the 1-1/4" male PVC adapter to the 1" and 1-1/4" PVC elbows.
12" OF
PVC PIPE
PROTRUD-
ING FROM
WELL
SEAL
WELL SEAL
1-1/4" PVC
ELBOW
1" PVC
ELBOW
1" PIPE 2"
SHORTER
THAN 1-1/4"
PIPE
1-1/4" MALE
PVC ADAPTER
1" FEMALE
PVC
ADAPTER
1" x 4"
NIPPLE
1-1/4" PVC PIPE
1" PVC PIPE
FEMALE ADAPTER
Open pressure regulator kit RPR.
STEP
10 Apply 4 wraps of teflon tape to
the male threads on the body
of the pressure regulator. With
pipe wrench, thread the pressure
regulator into 1" discharge at top of pump. Thread
pressure gauge RG-2 into side of pump case.
Thread plug into opening to right
STEP
of pressure regulator outlet.
11
PRIMING DEEP WELL JET PUMPS
Complete all electrical connections as specified on
STEP
12
pages 2 and 3 in the preinstallation instructions.
Thread 3/4" male PVC
STEP
adapter into pressure
13
regulator outlet.
Thread tank tee
STEP
RTT1-LF into pre-charged
14
pressure tank. Plug two
outlets on tank tee with
two 1/4" plugs.
Thread boiler drain into
STEP
front of tank tee. Thread
15
3/4" male PVC adapter
into inlet side of tank
tee. Connect to household
plumbing.
TO PRIME: Remove
STEP
pressure regulator,
16
put a garden hose
into the top of the
pump discharge and
fill and pump with
water until water overflows from top of pump. This may
take several minutes. Put regulator back on pump.
8
PRESSURE
REGULATOR
PRESSURE
REGULATOR
OUTLET
PLUG
3/4" MALE
PVC ADAPTER
1/4" PLUGS
TANK TEE
3/4" MALE
PVC
ADAPTER
1/2" BOILER
DRAIN