en Cleaning and servicing
¡ Liquid in the lighting can be dan-
gerous.
▶
The rinsing water must not run
into the light.
ATTENTION!
¡ Unsuitable cleaning products may
damage the surfaces of the appli-
ance.
▶
Do not use hard scouring pads
or cleaning sponges.
▶
Do not use harsh or abrasive
detergents.
▶
Do not use cleaning products
with a high alcohol content.
¡ If you clean fittings and accessor-
ies in the dishwasher, this may
cause them to become deformed
or discolour.
▶
Never clean shelves or contain-
ers in the dishwasher.
"Prepare the appliance for clean-
1.
ing." → Page 47
Clean the appliance, the fittings
2.
and the door seals clean with a
dish cloth, lukewarm water and a
little pH-neutral washing-up liquid.
Dry thoroughly with a soft, dry
3.
cloth.
Insert the fittings.
4.
Electrically connect the appliance.
5.
"Switch on the appliance."
6.
→ Page 42
Putting the food into the appliance.
7.
Cleaning the condensation
channel and drainage hole
Regularly clean the condensation
channel and drainage hole to ensure
that the condensation can drain.
Remove the pull-out container.
1.
→ "Removing pull-out containers",
Page 48
48
Carefully clean the condensation
2.
channel and the drainage hole,
e.g. using a moistened cotton bud.
→ Fig.
4
Cleaning the ventilation grille
Remove the ventilation grille for
1.
cleaning.
To do this, depress the clips in
‒
the ventilation openings and
simultaneously remove the vent-
ilation grille forwards.
→ Fig.
5
Clean the ventilation grille with
2.
lukewarm soapy water and a dish
cloth.
Let the ventilation grille dry com-
3.
pletely and insert it.
Removing the fittings
If you want to clean the fittings thor-
oughly, remove these from your ap-
pliance.
Removing the shelf
▶
Lift the shelf, pull it out, lower it
and swing it out to the side.
→ Fig.
6
Removing door racks
▶
Lift the door rack upwards and re-
move it.
→ Fig.
7
Removing pull-out containers
▶
Lift the container and pull it out.
→ Fig.
8
Remove the fruit and vegetable
container with the lid
Lift the container with the lid.
1.
Remove the container to the front.
2.
→ Fig.
9